36 degree oil drain 44mm bolt holes


Perfect for tight turbo instalations where angle fittings may be too long or straight drain outlets will put the oil drain at too shallow an angle.

Often overlooked it is very important to maintain as much slope as possible on your oil drain horizontal sections of hose or even worse U shaped sags in the hose can cause oil to back up and flood the turbo causing smoke and potentially damaging the turbo.
In many situations an angled drain outlet will make it much easier to maintain a more optimal slope across the length of the drain.
This design requires a 6mm stud and nut because a bolt will not fit in the tight area under the AN thread and 8mm nuts are too large.
Some turbos use 6mm bolts, others use 8mm bolts. It would be a waste to include hardware for different setups. If you need hardware Bel Metric Has a good selection of studs including step down which you can use to go from 8mm on the turbo to 6mm, and metric nuts including JIS.

List price: $0.00
Price: $28.00
Weight: 1 lb
Dimensions: 1 in × 1 in × 1 in

courtesy of webmatter.de